PF-KDX2 Profix KDX2 Mobile Infrared Curing Lamp
The Profix KDX2 is a mobile short-wave infrared curing lamp with two 1000 W tubes, an 800 × 800 mm curing area and a 9.5 kg body you can move panel to panel.
Versión en preparación: esta página se muestra en inglés por ahora.
Profix
The Profix KDX3 mobile infrared curing lamp runs three 1000 W tubes with two curing areas of 800 × 800 mm² and 800 × 500 mm² for panel-by-panel drying.
| Heating tubes | 3 × 1000 W halogen short-wave infrared, double-layer explosion-proof |
|---|---|
| Curing area | 800 × 800 mm² / 800 × 500 mm² |
| Net weight | 12.8 kg |
| Power | AC 200–240 V, 50 Hz |
The Profix KDX3 is a mobile paint curing lamp with three 1000 W halogen short-wave infrared tubes, giving it the output for faster cures and larger panels than the two-tube KDX2. Two curing areas are available — 800 × 800 mm² and 800 × 500 mm² — so the operator matches the lamp footprint to the panel being dried instead of over-baking a small area or under-covering a large one.
Like every lamp in the Profix curing line, it works by short-wave infrared: the energy penetrates the coating and dries it from the inside out, and because there is no air flow, dust is not blown onto fresh paint the way it is with hot-air blowing. Setup is genuinely plug-and-play — AC 200–240 V, 50 Hz, roll the 12.8 kg lamp to the vehicle and switch on. For bodyshops and prep bays that cure several panels a day, the KDX3 is the middle model of the range. It ships by sea, packed with your other Profix equipment in the same container. Ask Profix for pricing.
The Profix KDX2 is a mobile short-wave infrared curing lamp with two 1000 W tubes, an 800 × 800 mm curing area and a 9.5 kg body you can move panel to panel.
The Profix KDT3 ultra-low base curing lamp runs three 1000 W tubes over a 1200 × 1000 mm area, sized for fender and door zones on complete vehicles.