PF-KDX2 Profix KDX2 Mobile Infrared Curing Lamp
The Profix KDX2 is a mobile short-wave infrared curing lamp with two 1000 W tubes, an 800 × 800 mm curing area and a 9.5 kg body you can move panel to panel.
Versión en preparación: esta página se muestra en inglés por ahora.
Profix
The Profix KDT3 ultra-low base curing lamp runs three 1000 W tubes over a 1200 × 1000 mm area, sized for fender and door zones on complete vehicles.
| Heating tubes | 3 × 1000 W halogen short-wave infrared, double-layer explosion-proof |
|---|---|
| Curing area | 1200 × 1000 mm² |
| Design | ultra-low base for fender / door area drying |
| Net weight | 38 kg |
| Power | AC 200–400 V, 50 Hz |
The Profix KDT3 is a mobile paint curing lamp with an ultra-low base design, built to reach the panel zones that stand-mounted lamps struggle with: the drying lamp sits low to the floor, which suits the fender and door areas of a complete vehicle where a tall lamp post gets in the way of the panel. Three 1000 W halogen short-wave infrared tubes cover a curing area of 1200 × 1000 mm², the largest in the Profix curing lamp range.
The short-wave infrared principle is shared across the line: energy penetrates the coating and cures it from the inside out, and with no air stream there is no dust blown onto fresh paint as with hot-air drying. The lamp is plug-and-play mobile, moving between vehicles on its low base, and runs on AC 200–400 V, 50 Hz. At 38 kg it is the heavier unit of the three, matched to its larger area. It ships by sea as part of your Profix equipment order, container-packed for overseas delivery. Contact Profix for a quotation.
The Profix KDX2 is a mobile short-wave infrared curing lamp with two 1000 W tubes, an 800 × 800 mm curing area and a 9.5 kg body you can move panel to panel.
The Profix KDX3 mobile infrared curing lamp runs three 1000 W tubes with two curing areas of 800 × 800 mm² and 800 × 500 mm² for panel-by-panel drying.