ProFix Ring and Spade Terminal Assortment, 300 Pieces

What it is for

A crimped joint is a cold weld: the tool deforms the barrel and the metal of the terminal into the strands, and that is what makes it reliable. Solder needs heat near the insulation and a splice insulator; a crimp needs the right die, the right barrel size for the cable, and a pull test. This category covers the terminals and the tool that closes them.

Match the terminal to the cable cross-section — 1.5 mm² is the common automotive size, 2.5 mm² for higher-current circuits — and use a ratchet tool that will not release until the crimp is complete, which is the detail that stops an under-crimped joint passing a visual check and failing later.

Specification detail

300 pieces in a compartmented case, covering butt connectors or ring and spade terminals in the common automotive sizes and colours. Terminals accept 1.5–2.5 mm² cable; the tool variant adds a ratchet crimping plier with interchangeable dies for insulated and non-insulated barrels.

• Ratchet tool will not release until the crimp is complete
• Terminals sized for 1.5 mm² and 2.5 mm² automotive cable, colour-coded by size
• Insulated barrels with a copper sleeve, so the joint does not corrode
• Assortment boxes with the size and quantity printed on each compartment

Buying more than one

Orders are consolidated and re-weighed at intake, and freight is re-calculated on the actual chargeable weight. If you are ordering several items for one address, ask us for a combined quote before paying — mixing light and bulky items usually brings the freight share down.