ProFix Ratchet Crimping Tool with Assorted Terminals, 1200 Pieces

What it is for

A crimped joint is a cold weld: the tool deforms the barrel and the metal of the terminal into the strands, and that is what makes it reliable. Solder needs heat near the insulation and a splice insulator; a crimp needs the right die, the right barrel size for the cable, and a pull test. This category covers the terminals and the tool that closes them.

Match the terminal to the cable cross-section — 1.5 mm² is the common automotive size, 2.5 mm² for higher-current circuits — and use a ratchet tool that will not release until the crimp is complete, which is the detail that stops an under-crimped joint passing a visual check and failing later.

Specification detail

1200 pieces in a compartmented case, covering butt connectors or ring and spade terminals in the common automotive sizes and colours. Terminals accept 1.5–2.5 mm² cable; the tool variant adds a ratchet crimping plier with interchangeable dies for insulated and non-insulated barrels.

• Ratchet tool will not release until the crimp is complete
• Terminals sized for 1.5 mm² and 2.5 mm² automotive cable, colour-coded by size
• Insulated barrels with a copper sleeve, so the joint does not corrode
• Assortment boxes with the size and quantity printed on each compartment

Before you order

Check the size and quantity against your own job first: most returns in this category come from ordering the wrong diameter, finish or pack size rather than from a fault. If you are unsure, send us a photo or a measurement and we will confirm which variant you need.