ProFix Micro-Spray Head Kit, 20 Heads with Stakes

What it is for

Drip and micro-spray irrigation is the only method that puts water where the roots are rather than on the leaves. On a bed of tomatoes or a hedge line it cuts consumption by roughly half against a sprinkler, and it does it without wetting the foliage — which is where most fungal problems start.

This listing is the Micro-Spray Head Kit, 20 Heads with Stakes, in polypropylene, on G1/2 / G3/4 threads and rated for a working pressure of 3.0 bar. Lay it as a single line with a pressure-compensating emitter every 30 to 40 cm; on a long run, split it into two shorter lines rather than pushing one line past its pressure limit.

Specification detail

Micro-Spray Head Kit, 20 Heads with Stakes. polypropylene parts with G1/2 / G3/4 threads, working pressure 3.0 bar. Emitters are pressure-compensating, so the last one on the line delivers the same as the first.

• Water reaches the root zone — no wet foliage, no evaporation loss
• Pressure-compensating emitters keep the flow even along the whole line
• G1/2 / G3/4 threads connect straight to a standard UK or EU tap or timer
• Extendable in 15 m steps — buy one line now and add to it next season

Before you order

Check the size and quantity against your own job first: most returns in this category come from ordering the wrong diameter, finish or pack size rather than from a fault. If you are unsure, send us a photo or a measurement and we will confirm which variant you need.