ProFix Digital Angle Finder, 300 mm, aluminium alloy

What it is for

An angle finder is used where a protractor and a straight edge will not fit: setting a suspension arm, matching a driveshaft flange, checking a mitre on a trim cut. The number it gives is only useful if the reference face is flat, so the two rules are to zero it on the surface you are working from, and to hold the body against the work rather than the blade.

300 mm is long enough to reach across a flange and short enough to go back in the tool bag. The display reads in 0.1° steps and holds a value while you move to the next fixing, which is what turns a two-person job into a one-person job.

Specification detail

300 mm digital angle finder reading 0–360° in 0.1° steps, aluminium alloy body with hold, zero-set and a locking blade. Powered by 2 × AAA batteries with automatic power-off; accuracy ±0.1° measured at the reference face.

• Reads 0–360° in 0.1° steps — a protractor cannot do this between two flanges
• Hold button keeps the value while you move to the next fixing
• Zero-set on any surface, so a sloped workshop floor does not become an error
• aluminium alloy body with a locking blade that stays where you set it

Buying more than one

Orders are consolidated and re-weighed at intake, and freight is re-calculated on the actual chargeable weight. If you are ordering several items for one address, ask us for a combined quote before paying — mixing light and bulky items usually brings the freight share down.