BN-BDJ001 Super-Thin Wheel Alignment Scissor Lift – 4.5 m, No Trench, 140 mm Drive-Over Height
140 mm high, no trench: a 5,000 kg alignment lift you can drive straight over.
Deutsche Fassung in Vorbereitung — diese Seite wird vorerst auf Englisch angezeigt.
Profix
The alignment bay that disappears into your floor — 5,000 kg capacity, flush at 330 mm, and 2,080 mm of clear working height the moment it rises.
| Model | EH500A |
|---|---|
| Type | In-ground / underground scissor lift, wheel alignment |
| Main lifting capacity | 5,000 kg |
| Secondary jack capacity | 3,500 kg |
| Lifting height | 2,080 mm |
| Secondary jack lifting height | 425 mm |
| Platform length | 5,000 mm |
| Platform width | 670 mm |
| Platform spacing | 900 mm |
| Motor power | 3 kW |
| Rise / fall time | 50 s |
| System pressure | 250 bar (25 MPa) |
| Net / gross weight | 2,450 kg / 2,500 kg |
| Control voltage | 24 V |
| Certification | CE, ISO 9001 |
EH500A — 5 Ton Underground Wheel Alignment Scissor Lift
When floor space is the constraint, the answer is not a smaller lift - it is a lift that lives
under the floor. The EH500A is a 5,000 kg in-ground scissor lift built for wheel alignment bays:
closed, its platforms sit just 330 mm above the slab, so vehicles drive straight over it and the
bay doubles as a normal service position. Raise it and you get 2,080 mm of clear, unobstructed
working height enough to stand under a van, swing a wrench, and run a full four-wheel alignment
without a column, crossbar or overhead beam anywhere in the frame.
Built to carry, not just to lift. The support bars are cut from 16Mn plate, spliced and
riveted rather than folded from mild steel — the reason this platform holds 5,000 kg without
flex and stays level through the full 2,080 mm stroke. The platforms are 5,000 mm long and
670 mm wide, set on 900 mm centres, with a graphic anti-slip top surface that lets a low car
roll on smoothly at a shallow approach angle.
A second lift built in. The 3,500 kg secondary jack is standard, not an add-on. Its
single-sided pull-out platform slides out to suit different wheelbase models, so a compact
hatchback and a long-wheelbase van both get their wheels free for alignment, brake and
suspension work. Order the double-sided version if your bay runs mixed traffic all day.
Safety is specified, not optional. Mechanical safety locks hold the platform at every
working height. A hydraulic pipe-rupture valve stops the platform from dropping if a hose is
cut. A height limit switch prevents over-travel. The control circuit runs on 24 V, which matters
in a bay that sees water, coolant and wheel wash. Every unit is proof-tested at 120% dynamic
and 150% static load before it ships, and carries CE marking with an ISO 9001 certified build.
Installation. In-ground installation, pit built to the foundation drawing supplied with
each unit pre-embed 50 x 50 mm angle steel around the pit, keep the concrete base at
200 mm minimum thickness, and provide a drain hole at the low point. A 3 kW motor drives the
50-second rise/fall cycle on a standard workshop supply. Two people, one day, once the pit
is cured.
140 mm high, no trench: a 5,000 kg alignment lift you can drive straight over.
5 m deck, 140 mm high, no trench: a van-sized alignment lift with no civil works.
One deck, every vehicle: a sliding sub-platform covering 665-1,560 mm, with no trench.